Difference Between Similar Terms and Objects

Difference Between Router and Bridge

router-dbRouter vs Bridge

Basically, a router determines the fastest way possible, which is also usually the shortest way possible, in a particular network. It has the capability to route the packets through the most effective determined route.

Routers have the ability to allow hosts that aren’t practically on the same logical network, to be able to communicate with each other. Every router can receive chunks of data, which are called packets, on an interface. It will then forward the data packets to the intended location in the most efficient manner. The directing, or routing, of packets is based on the routing table, by allowing routers to know where a particular network is found.

Aside from being a device, a router can be software in a computer. Routers should be, at least, connected to two networks. It is sort of a gateway to another network. Functionally, it is capable of generating traffic between logically separated networks.

The third layer, which is the network layer of the OSI model, is where routers operate. Understanding the OSI model is the key to figuring out differences between routers, gateways and bridges. The network layer is responsible for moving packets from a particular port to another. It is based on addresses (L3) such as, IPv4, IPv6, and IPX, or Appletalk, addresses.

A bridge, or network bridge, is a device that can also connect networks, but unlike a router, its operation does not include the network layer of the OSI model. Only the one and two layers are included in a bridge’s operation – the physical layer and the data link layer respectively. It can only connect existing networks that you can access. It is basically not concerned with, and is unable to distinguish networks, unlike a router. They can only be used when you intend to connect networks of same type.

In bridging mode, the process does not bother to understand network communications protocol, such as IP addresses. It only recognizes and considers the physical means, like the Media Access Control (MAC) address, which is usually an Ethernet. Thus, traffic will only exist in a bridged network if the networks concerned are logically the same.

In terms of practicality, routers are more favored, because routing is more efficient and offers easier call management. Bridging is required for cases where you cannot ‘subnet’ an IP network, and for cases where you need to utilize non-routable protocols, like DECnet or NetBIOS.

A router, or routing, is considered more intelligent than a bridge, or bridging, because they make smarter decisions. It only sends a packet to its intended destination, eliminating unnecessary traffic. With regards to routers, there is improved call management, while for bridging, call management and performance is sacrificed, as packets are automatically broadcasted to all the computers on a network.

Summary:

1. Routers are more intelligent than bridges.

2. Routers allow hosts that aren’t practically on the same logical network to be able to communicate with each other, while bridges can only connect networks that are logically the same.

3. Routers operate at the layer 3 (network layer) of the OSI model, while bridges are only at the layer 2 (Data link layer).

4. Routers understand and consider IP and IPX addresses, while bridges do not, and instead they recognize MAC addresses.

5. Routing is more efficient, and has better call management, than bridging.

Sharing is caring!


Search DifferenceBetween.net :




Email This Post Email This Post : If you like this article or our site. Please spread the word. Share it with your friends/family.


24 Comments

  1. i liked the differrences vey much.
    it helped very much.
    i thanks u a lot.
    thank you!

  2. These differences are very much helpful in distinguishing between router and bridge….Thankss a lot.

  3. i m satisfy with ur info.
    thank you.

  4. very gud info……
    thanks

  5. thanks alotttttttttt………………………………………………………………………………………..

  6. this is to much helpfull …..!!!
    thank you ….!!!!

  7. i satisfied

  8. veeeeeeeeerrrrryyyy hlpfull
    THANK YOU VERRRRRYYYY MUUUUCCHHHHH
    II TTTTAAAANNNK YOU VERYYY MUC
    PLESE MAKE MORRRRREEE
    SO I KNOW VHAT TO BUY NEXT TIME AS WELL.
    THANK YOU
    I NAM PLEEASSESD WITH DIS INFORMOTION
    JUUUUUULLLLIIIEEEE!!!!!!!!!!!!!!!!!!!

  9. It gets a bit complicated after the first two paragraphs, can u simplfy the info and lose some acronyms please. Otherwise it was great

  10. ummmmmmmmmmmma…thank u so mush…

  11. thanks a lot you answers have helped mi distinguish the two

  12. Thanks guys this was helpful.i am setting up a wireless network so trying to do it the right way. I’m not really experienced in that field so the help is really a blessing.

  13. realy its very helpfull..

  14. Helpfull very very

  15. I thank you very much!

  16. Thanks for the clarification, particularly for giving me a hint toward the preferred approach if both are possible.

  17. memes are great, beams melt, and beans grow.

    Words of wisdom, words to live by

  18. when you setup a wireless bridge do you have to connect anything to the rj45 port?

    if I setup a wireless bridge can I connect a second router to the bridge rj45 port?

    Does the second location wireless device just broadcast to the wireless bridge and it broadcast to the wireless router?

  19. when you setup a wireless bridge do you have to connect anything to the rj45 port?

    if I setup a wireless bridge can I connect a second router to the bridge rj45 port?

    Does the second location wireless device just broadcast to the wireless bridge and it broadcast to the wireless router?

    If the second router could be connected to the wireless bridge can it have a different IP or must it be the same so the whole network can access that device?

Leave a Response

Please note: comment moderation is enabled and may delay your comment. There is no need to resubmit your comment.

Articles on DifferenceBetween.net are general information, and are not intended to substitute for professional advice. The information is "AS IS", "WITH ALL FAULTS". User assumes all risk of use, damage, or injury. You agree that we have no liability for any damages.


See more about : ,
Protected by Copyscape Plagiarism Finder